A concrete hardstanding for a Borstal drive
A hardstanding is a slab a car can stand on, and on a Borstal plot it is often the only flat ground there is. The slope in front of the house does most of the work first: a cut into the bank, a sub-base that holds, and a concrete top thick enough for a car's weight. This guide works a hardstanding of 5 by 3 metres from the dig to the cement count, for one order in the ME1 district.
Rochester BM is the Rochester and Borstal delivery site of Discount Builders Merchants (KENT) LTD, the builders' merchant at Lower Road, Northfleet, DA11 9BB. There is one yard, and orders are placed on www.discountbm.co.uk.

Reading the slope and the bank
Borstal is built on a hill, and a drive usually runs up or across a slope rather than along a flat plot. Before the dig, measure the fall from the road to the house wall and the height of any bank behind the drive. A cut into a bank steepens the ground above it, so the bank is looked at before a spade goes in.
If the bank stands higher than the hardstanding is long, the job becomes a retaining question, and that belongs to someone who can design a wall. A small cut with a sound bank above it is a drive job, and this guide assumes that is the case.
The dig and the sub-base
A car needs a deeper base than a patio, so the dig for a hardstanding goes further down. The base under it is type 1, put down in layers and rammed hard, to a compacted depth of about 150 mm. Stone of that depth on firm ground carries a car without the surface settling into ruts.
Where the ground is soft or has been made up, lay a fabric first, lapped at the joints and turned up the sides. Fall the finished surface away from the house, so that water runs off the concrete towards the road and not down the wall.
Concrete for a car
The concrete top is 150 mm thick. At 5 by 3 metres that is 2.25 cubic metres, which is more than most people want to mix by hand. A mixer hired for the day makes the work far easier, and the bags are opened only as the mixer needs them.
For a car, order a ready-mixed C25 or a designed mix. A 1:5 hand mix of ballast and cement, measured by volume, suits foot traffic and sheds only. Each cubic metre of the hand mix needs 1.9 tonnes of 20 mm stone and 13 bags of 25 kg cement, so the order is counted from the volume. Pour in one run rather than in sections, so no joint sits where a wheel will cross it while the concrete is young.
Reinforcement and joints
A plain concrete top on a sound base is common for a car standing still. Where the drive is steep, or a car turns on it, the design may call for steel mesh or bars. That decision belongs to the designer, and mesh is not in this order. Joints are formed where the slab changes direction, so that any crack follows a line rather than a random path.
Cut the joints within a day or two of pouring, before the surface hardens and cracks on its own. Finish the top with a wood float for grip, which holds better on a slope than a steel finish does.
Keeping the surface sound
For several days after the pour, keep the new surface wet under sacking or plastic so that it sets slowly. A slab that dries too fast on a warm day loses strength at the top and dusts under the wheels. In frost, keep the concrete off the ground and protect it until it has set.
Keep the cement under cover and off the damp ground, and use the oldest bags first. A bag that has taken up moisture sets in lumps, and lumps in a mix spoil both the finish and the strength.
Rules of thumb
| Volume | Take the length, times the width, times the depth, all in metres, to get cubic metres. For 5 by 3 metres at 150 mm that is 2.25. |
|---|---|
| Ballast | About 1.9 tonnes of ballast for every cubic metre mixed. |
| Cement | About 13 bags of 25 kg cement for every cubic metre mixed at 1:5. |
| Sub-base | At 150 mm compacted, a tonne of type 1 covers roughly 3.3 square metres, against about 5 at 100 mm. |
| Bulk bags | Each bag holds about 0.8 tonnes. Count the tonnes, then round up to the next whole bag. |
The shop has calculators that turn a measurement into a quantity.
Worked order: A 5 by 3 metre concrete hardstanding for a car in Borstal
| Product | Quantity | What it is for | Cost |
|---|---|---|---|
| Bulk Type 1 Roadstone | 6 at £45.83 | A 150 mm sub-base over 15 square metres is 2.25 cubic metres. At 3.3 square metres to the tonne that is 4.5 tonnes, which is 5.6 bags, so six at 0.8 tonnes each. | £274.98 |
| Bulk Bag Ballast 20mm | 6 at £40.00 | The concrete is 2.25 cubic metres. Ballast at 1.9 tonnes for each cubic metre gives 4.3 tonnes, which is 5.3 bags of 0.8 tonnes, so six. | £240.00 |
| 25kg Mastercrete Cement (plastic) | 30 at £7.99 | At 13 bags for each cubic metre, the 2.25 cubic metres comes to 29.25 bags, rounded up to 30. | £239.70 |
| Goods | £754.68 | ||
| Delivery to ME1 | £0.00 | ||
| Delivered total ex VAT | £754.68 | ||
| Delivered total inc VAT | £905.62 | ||
Bulk bags: the bags in this order are counted at about 0.8 tonnes each. That is a planning figure. The shop does not publish a weight for a bulk bag, so confirm the number of bags with the yard before ordering.
Not in this order: Any mesh or bars the designer asks for, the fabric under the stone, the edge boards and pegs, any retaining wall for a high bank, and the mixer hire for the day.
The quantities are a starting point for a job of this size. Put the same goods in a basket on www.discountbm.co.uk with your own postcode to see the figure for your order, or send the yard your list.
On the shop today
The products this guide talks about, from the shop's Cements aisle. Prices last checked .
-
25kg Mastercrete Cement (plastic)
each
£9.59 inc VAT
£7.99 ex VAT
In the yard
-
20kg C40 High Strength Concrete
each
£8.10 inc VAT
£6.75 ex VAT
In the yard
-
20kg Masonry Mortar Mix
each
£10.99 inc VAT
£9.16 ex VAT
In the yard
Prices are the shop's prices today. Stock and ordering are on www.discountbm.co.uk.
Bagged cement and mortar mix for ME1 jobs See all Cements on the shop
Delivery to Rochester and Borstal
- ME1
-
Free when the goods reach £41.66 ex VAT (£49.99 inc VAT).
A smaller order pays the difference up to that amount: goods of £25.00 ex VAT (£30.00 inc VAT) pay £16.66 ex VAT (£19.99 inc VAT) for delivery.
More guides for Rochester and Borstal
- A yellow stock garden wall for ME1 A one-brick front wall of yellow stock for a Rochester terrace, with its footing, mortar and one worked order priced for the ME1 district.
- A single-leaf block store on a strip footing Blockwork for a garden store in Wouldham or Burham, built as one leaf on a strip footing, with a door opening and a worked order for ME1.
- Type 1, edging and fabric for a patio base Sub-base, fabric, edging and haunch for a 4 by 3 metre patio in a Burham garden, with a worked ME1 order. The slabs are not in the order.